Readynas duo how long to boot

Contact Support. Select a product or category below for specific instructions. N Routers. Nighthawk Routers. Powerline and Wall Plug Extenders. Wireless Access Points. Other Business Products. Mobile Broadband. Press the Power button and continue to hold it for 5 seconds.

Release after all Disk LEDs flash 1 time. On the off chance if you see either of these error messages, it can be because of a corrupt OS installation on the root partition.

In the event that you are not concerned with partitions or data on these disks and want to continue to wipe the disks, then perform a factory default from the Boot Menu. Possibilities are that these disks have been used elsewhere in a computer or even another NAS and the ReadyNAS is taking a preventive step in not wiping off the data on these disks.

It can take a while and any issues are reported in RAIDar. In case RAIDar shows that a disk has failed, then you should do the following:. Remove the failed disk. Power down the ReadyNAS. Search Advanced…. Log in. Trending Search forums. What's new.

New posts Latest activity. Thread starter dmw16 Start date Jan 2, Sidebar Sidebar. Forums Hardware and Technology Networking. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. Previous Next. Nov 12, 7, 0 0. The device would not post power LED blinking and fan full speed. I let it run for about an hour but still blinking blue LED and fans full speed. It boots up but I am getting error codes via the LED's that the drive is damaged 2 blinks on some restarts and 3 on others.

So I pull the drives and put them in another machine to run WD Lifeguard on them. One drive is bad error code and the other reports fine. I pull the bad drive and put the good one back in my ReadyNAS. So I try the "soft" reset, wait an hour and still fans full and blinking led.